Engineering, 18.12.2020 21:50 marilyn73471
Design and analyze cam profiles. Using MATLAB code,
1. Draw the displacement and velocity diagrams for the complete motion cycle, clearly demarcating the different regions of motion
2. Draw the pitch curve showing the Base circle as well.
3. Keep the base circle radius fixed and change the ‘lift’ value by 30% in the increments of 10%. Study the effect of this on the pitch curve compared to the original curve got in (2) above.
Speed of the cam can be assumed if necessary.
Note:
Follower type: Knife edge
Event sequence: Dwell-Rise-Dwell-Fall
Event: Rise from 120 to 210 and Fall from 270 to 360
Motion type: Parabolic
Rb(mm):65, Rf(mm):16, Lift(mm):39
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:20
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
Engineering, 04.07.2019 19:20
In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.
Answers: 3
You know the right answer?
Design and analyze cam profiles. Using MATLAB code,
1. Draw the displacement and velocity diagrams...
Questions
Mathematics, 16.11.2020 03:00
Mathematics, 16.11.2020 03:00
Mathematics, 16.11.2020 03:00
Mathematics, 16.11.2020 03:00
Advanced Placement (AP), 16.11.2020 03:00
English, 16.11.2020 03:00
Physics, 16.11.2020 03:00
Mathematics, 16.11.2020 03:00
Mathematics, 16.11.2020 03:00
