Engineering, 21.12.2020 23:50 deonnaturner68p7hz7y
Stress that acts in the plane of a cut section, rather than at right angles to the section is called:
a. Shear
b. Tension
c. Compression
d. Bending
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
Stress that acts in the plane of a cut section, rather than at right angles to the section is called...
Questions
Social Studies, 21.07.2019 08:30
Spanish, 21.07.2019 08:30
Mathematics, 21.07.2019 08:30
Mathematics, 21.07.2019 08:30
History, 21.07.2019 08:30
Social Studies, 21.07.2019 08:30
Mathematics, 21.07.2019 08:30
Mathematics, 21.07.2019 08:30
