Can someone solve this question, please? "strength of materials"
p1 =1188
p2=1890
p3= 19...
Engineering, 29.12.2020 22:50 eyeneedalife
Can someone solve this question, please? "strength of materials"
p1 =1188
p2=1890
p3= 1999
L= 159 mm
t= 5.88 mm
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 18:20
Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)
Answers: 2
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
Questions
Mathematics, 25.06.2019 07:30
Mathematics, 25.06.2019 07:30
Mathematics, 25.06.2019 07:30
Mathematics, 25.06.2019 07:30
History, 25.06.2019 07:30
Health, 25.06.2019 07:30
French, 25.06.2019 07:30
