![subject](/tpl/images/cats/User.png)
Engineering, 31.12.2020 07:40 Knownothing
Multiple Choice
Which option best characterizes Reese's choice of less-than-optimal materials in the following scenario?
Reese has just designed a vándshield for an extremely lightweidot car that can be transported by the military via helicopter. The engineers
wanted to use a specially formulated glass that is lighter than ordinary glass, but the cost was far above the budgeted amount for the
project's materials. Reese decides to use a plastic windshield instead.
Economic considerations should never be placed above safety when designing a model
Economic considerations can endanger the safety of a model.
Economic considerations must be considered vihen designing a model
Economic considerations are the most important factor vihen designing a model
![ansver](/tpl/images/cats/User.png)
Answers: 3
![](/tpl/images/ask_question.png)
![](/tpl/images/ask_question_mob.png)
Another question on Engineering
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20
Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process
Answers: 1
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
You know the right answer?
Multiple Choice
Which option best characterizes Reese's choice of less-than-optimal materials in th...
Questions
![question](/tpl/images/cats/mkx.png)
![question](/tpl/images/cats/obshestvoznanie.png)
![question](/tpl/images/cats/obshestvoznanie.png)
![question](/tpl/images/cats/istoriya.png)
![question](/tpl/images/cats/obshestvoznanie.png)
![question](/tpl/images/cats/fizika.png)
![question](/tpl/images/cats/ekonomika.png)
![question](/tpl/images/cats/health.png)
![question](/tpl/images/cats/ekonomika.png)
![question](/tpl/images/cats/ekonomika.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/ekonomika.png)
![question](/tpl/images/cats/informatica.png)
Computers and Technology, 20.12.2019 05:31
![question](/tpl/images/cats/obshestvoznanie.png)
![question](/tpl/images/cats/ekonomika.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/istoriya.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/biologiya.png)