B)0.0005 to 0.0025 inch
Engineering, 08.01.2021 21:00 westhacker1663
Typical journal-to-bearing clearance is
A) 0.00015 to 0.00018 inch
B)0.0005 to 0.0025 inch
C) 0.15 to 0.25 inch
D)0.02 to 0.035 inch
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
You know the right answer?
Typical journal-to-bearing clearance is
A) 0.00015 to 0.00018 inch
B)0.0005 to 0.0025 inch
B)0.0005 to 0.0025 inch
Questions
Physics, 20.10.2020 01:01
Biology, 20.10.2020 01:01
History, 20.10.2020 01:01
Biology, 20.10.2020 01:01
Mathematics, 20.10.2020 01:01
Biology, 20.10.2020 01:01
