subject
Engineering, 11.01.2021 02:20 karlamiddleschool

Which explanation best identifies why the company in the following scenario has decided against investing in solar energy? A company in Miami, Florida, is considering an alternative energy source in order to cut down on its fuel costs. The company has thought about solar energy but has decided against it for the time being.

The company found the negative environmental effects of solar energy disheartening.

The company found the amount of sunlight in the area unreliable.

The company found the cost of the required photovoltaic cells too expensive.

The company found the natural resources used in solar energy too limited.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
You know the right answer?
Which explanation best identifies why the company in the following scenario has decided against inve...
Questions
question
Law, 27.02.2020 18:01
question
Engineering, 27.02.2020 18:01
Questions on the website: 13722362