Engineering, 20.01.2021 01:30 lilycious3986
Tech A says as engine load increases, the line pressure in a transmission must increase for greater holding force in clutches and bands. Tech B says some transmissions can achieve 200 pounds per square inch (psi) of line pressure during wide open throttle (WOT). Who is correct
Answers: 3
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
Tech A says as engine load increases, the line pressure in a transmission must increase for greater...
Physics, 09.01.2021 14:00
Social Studies, 09.01.2021 14:00
Social Studies, 09.01.2021 14:00
English, 09.01.2021 14:00
Mathematics, 09.01.2021 14:00
Social Studies, 09.01.2021 14:00
Physics, 09.01.2021 14:00
Physics, 09.01.2021 14:00
Mathematics, 09.01.2021 14:00
Mathematics, 09.01.2021 14:00
Physics, 09.01.2021 14:00