Engineering, 26.01.2021 04:50 ranaaf

PLEASE HELP! |BRAINLIEST| Dennis Mallory has recently completed two years of flight training at his local communlty college. Although his Initial career plan was to become a commercial pllot, his time spent flying convinced him that he is far more Interested in a
career as an avionics mechanic. He and 14 other prospective avionics students are meeting today with you, the school's
most experienced avionics mechanics Instructor, at the maintenance facility for one of the nation's largest commercial
alrlines. In an essay of approximately 225 words describe what you will discuss with these prospective students with
respect to the training required to become a certified avionics mechanic, what specialties exist in the career, the type of
work avionics mechanics regularly perform, what skills and personal attributes the successful mechanic displays, and
any opportunities for career advancement,

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3

Answers: 2

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

You know the right answer?

PLEASE HELP! |BRAINLIEST| Dennis Mallory has recently completed two years of flight training at his...

Questions