Engineering, 26.01.2021 05:00 jimennacastillo15

PLEASE HELP! !BRAINLIEST!Dennis Mallory has recently completed two years of flight training at his local communlty college. Although his Initial career plan was to become a commercial pllot, his time spent flying convinced him that he is far more Interested in a
career as an avionics mechanic. He and 14 other prospective avionics students are meeting today with you, the school's
most experienced avionics mechanics Instructor, at the maintenance facility for one of the nation's largest commercial
alrlines. In an essay of approximately 225 words describe what you will discuss with these prospective students with
respect to the training required to become a certified avionics mechanic, what specialties exist in the career, the type of
work avionics mechanics regularly perform, what skills and personal attributes the successful mechanic displays, and
any opportunities for career advancement,

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

You know the right answer?

PLEASE HELP! !BRAINLIEST!Dennis Mallory has recently completed two years of flight training at his l...

Questions