subject
Engineering, 28.01.2021 20:00 lizzyhearts

The wall of a rocket nozzle is of thickness L = 25 mm and is made from a high alloy steel for which  = 8000 kg/m3, c = 500 J/kgK and k = 25 W/m. K. During a test firing, the wall is initially at Ti = 25C and its inner surface is exposed to hot combustion gases for which h = 500 W/m2.K and T = 1750C. The outer surface is well insulated.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
You know the right answer?
The wall of a rocket nozzle is of thickness L = 25 mm and is made from a high alloy steel for which...
Questions
question
Mathematics, 16.10.2019 21:30
question
Mathematics, 16.10.2019 21:30
question
Mathematics, 16.10.2019 21:30
Questions on the website: 13722360