Engineering, 30.01.2021 14:00 robert7248

Task 3 - Prepare a PowerPoint for introducing 3D CAD modelling Your supervisor asked you to prepare a PowerPoint presentation to follow up the impact of
CAD system upgrade in company (from hand drawing to CAD) to the top management. Your
PowerPoint shall focus on evaluating the impact of the use of 2D and 3D CAD models on
final design requirements. Your evaluation must cover all the following three aspects
1. evaluate 2D and 3D drawings from a customer perspective. This links directly with
the P7 and M3 criteria.
2. compare and contrast the impact on customers of producing drawings using 2D and
3D CAD
3. predict how customers might use the information produced
The PowerPoint presentation file is limited to 15 pages

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

Task 3 - Prepare a PowerPoint for introducing 3D CAD modelling Your supervisor asked you to prepare...

Questions