Engineering, 02.02.2021 16:10 giraffegurl
When adding a 90* bend to a piece of acrylic put the following steps in the correct order.
a) Use a ruler to measure
b) Draw a line to show the bend line
c) Test with a try square
d) Heat on the strip heater
e) Bend into shape
f) Allow to cool
Can someone please put these in order for me haha
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
Engineering, 04.07.2019 18:20
Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process
Answers: 1
You know the right answer?
When adding a 90* bend to a piece of acrylic put the following steps in the correct order.
a) Use a...
Questions
Computers and Technology, 14.12.2019 02:31
Mathematics, 14.12.2019 02:31
Mathematics, 14.12.2019 02:31
Physics, 14.12.2019 02:31
Social Studies, 14.12.2019 02:31
English, 14.12.2019 02:31
Mathematics, 14.12.2019 02:31
Geography, 14.12.2019 02:31
Mathematics, 14.12.2019 02:31
