Engineering, 05.02.2021 21:50 Kalij13

Your stomach is a chemical reactor. When you devour a fast food $0.99 hamburger in about a minute, it acts like an instantaneous input of 350 g of food entering the stomach. In response, the stomach starts producing gastric liquids (acids), which are continuously excreted into the stomach at a rate of 12.0 mL/min as the hamburger is digested. The fluid also leaves the stomach to the small intestine at a flow rate of 12.0 mL/min, so the volume of the liquid in the stomach stays constant at 1.15 L. The hamburger digestion rate constant is 1.33 hr-1. A. What kind of ideal reactor would you model your stomach as?
B. What fraction of the hamburger's mass will remain undigested in your stomach one hour after you eat the hamburger?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

You know the right answer?

Your stomach is a chemical reactor. When you devour a fast food $0.99 hamburger in about a minute, i...

Questions