Engineering, 12.02.2021 01:00 campbellkruger

Estimate the production of a tracked Caterpillar D5H with a straight blade using the production curves and correction table shown in page 19 and page 20 from . Excellent operator skill, loose stockpile material with a density of 2,000 lb/lcy, normal visibility, and 55 min/hr efficiency. The bulldozer will be pushing downhill on a 9% slope. Average distance 200 feet. a. What is the production rate in lcy/hr?
b. What would the production rate be with an average operator?
c. If you have a choice between an average operator making $15/hr and an excellent operator making $19/hr, which would be the cheapest alternative? Explain your answer

I put the slides you need

Estimate the production of a tracked Caterpillar D5H with a straight blade using the production cur

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

Estimate the production of a tracked Caterpillar D5H with a straight blade using the production curv...

Questions