Engineering, 18.02.2021 21:30 kyahshayovvu24
Consider that we have a circuit that has 17-bit inputs. We also have given a control signal which helps us erase some bits from the input data. If the control signal is Logical 1, the last 5 bits are erased (equal to Logical 0) and for the Logical 0 control signal, the first 7 bits are erased. Write down the behavioral level Verilog HDL code for this circuit.
Answers: 2
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Engineering, 04.07.2019 19:10
Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg.m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?
Answers: 3
Consider that we have a circuit that has 17-bit inputs. We also have given a control signal which he...
Biology, 08.12.2020 02:00
History, 08.12.2020 02:00
World Languages, 08.12.2020 02:00
Mathematics, 08.12.2020 02:00
World Languages, 08.12.2020 02:00
English, 08.12.2020 02:00
Arts, 08.12.2020 02:00
Mathematics, 08.12.2020 02:00
Mathematics, 08.12.2020 02:00
History, 08.12.2020 02:00