Exam Lesson Name: Introduction to CAD Technology
Exam number: 502016RR
Exam Guidelines
...
Engineering, 19.02.2021 01:00 chocolate4550
Exam Lesson Name: Introduction to CAD Technology
Exam number: 502016RR
Exam Guidelines
Exam Instructions
Question 1 of 20
Select the best answer for the question
1. If designers are concerned that an insulated component might lose too much heat through one of its sides, they could subject its CAD files to a
O A. kinematic analysis.
O B. thermal analysis.
O C. field analysis.
OD. modal analysis.
Mark for review (Will be highlighted on the review page)
Answers: 2
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Mathematics, 25.03.2021 14:00
Mathematics, 25.03.2021 14:00
Social Studies, 25.03.2021 14:00
Mathematics, 25.03.2021 14:00
English, 25.03.2021 14:00
English, 25.03.2021 14:00
Computers and Technology, 25.03.2021 14:00
History, 25.03.2021 14:00
Mathematics, 25.03.2021 14:00
English, 25.03.2021 14:00