Engineering, 19.02.2021 02:50 nataliem02
Design of amplifiers. The voltage produced by a thermocouple varies between 0 and 100 mV for the span it senses. The output required for display Interfacing methods and circuits 751 is between 0 V and 5 V. An operational amplifier with an open-loop input impedance of 10 MW and an open-loop gain of 106 is used for amplification. Devise a circuit, including the required resistors, to produce the required output
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 Β°c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.
Answers: 3
Engineering, 04.07.2019 19:10
Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?
Answers: 3
Engineering, 04.07.2019 19:10
An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed
Answers: 3
Design of amplifiers. The voltage produced by a thermocouple varies between 0 and 100 mV for the spa...
Mathematics, 17.12.2020 07:50
Mathematics, 17.12.2020 07:50
English, 17.12.2020 07:50
Mathematics, 17.12.2020 07:50
English, 17.12.2020 07:50
Arts, 17.12.2020 07:50
Computers and Technology, 17.12.2020 07:50
Chemistry, 17.12.2020 07:50
History, 17.12.2020 07:50
Mathematics, 17.12.2020 07:50
Computers and Technology, 17.12.2020 07:50
History, 17.12.2020 07:50