subject
Engineering, 25.02.2021 20:40 hamptonjeleesa

5. The U. S. Constitution, Article 1, Section 8, gives Congress the power to grant copyrights and patents to inventors. Why does this serve as an incentive in a market economy?
a. It offers inventors the guarantee that the government will cover their losses.
b. It offers other producers the opportunity to copy the invention.
c. It offers inventors the possibility of making profits in the market.
d. It offers other producers government grants to compete in the market.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
5. The U. S. Constitution, Article 1, Section 8, gives Congress the power to grant copyrights and p...
Questions
question
Biology, 23.03.2021 03:40
question
Mathematics, 23.03.2021 03:40
question
Biology, 23.03.2021 03:40
Questions on the website: 13722359