Engineering, 28.02.2021 16:10 lliaaaa

Below are a series of statements about future developments in metal alloys for airframe components. Select any statements that are correct. Note: Negative marking will be applied for any incorrect answers in this question, so you cannot get full marks by simply selecting all the
options! Only select answers that you are sure are correct.
Advanced Al-Li alloys offer improved specific fracture toughness and fatigue properties, offering customers potential savings in fuel and
maintainance costs.
5000 series Al-alloys are expected to see wide use in future airframes due to improved corrosion resistance.
Aircraft manufacturers are considering applications of advanced Al-Li alloys because they offer increased specific stiffness compared to
conventional aluminium alloys.
Airframe manufacturers are seeking alloys that offer improved corrosion resistance mainly because this allows significant weight savings and
therefore a reduction in fuel costs.
Advanced Al-Li alloys offer an order magnitude increase in strength compared to current alloys, so are a competitive material for wing skins in
future civil aircraft.
Airframe manufacturers are seeking alloys that offer improved corrosion resistance because this offers airlines the benefit of reduced
maintainance costs.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

You know the right answer?

Below are a series of statements about future developments in metal alloys for airframe components....

Questions