Engineering, 28.02.2021 16:40 Prettygirlyaya

Derive a basic analytical model for the volume build rate of a direct, single-laser SL process in terms of the following parameters: Effective laser spot size, the cured line width on the surface (Lw) and scan speed (V); liquid resin layer thickness (Zr) and cure (volume) shrinkage (S); and the time per layer to configure the liquid, wiper time (tw). Assume neighboring tracks are just touching (not overlapping). Apply this model to the following problems: a. For Zr = Lw = 0.1 mm, Vs = 2000 mm/s, and S = 15 vol %, what is the volume build rate per hour, neglecting the wiper time.
b. From (a), calculate the time to build a single 10 x 10 cm layer and a 10-cm cube (= 1 L).
c. For what wiper cycle time, does the wiper time add 10% to the total time in this case.
d. For what (smaller) layer area does the wiper time double the total time.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Oxygen at 300 kpa and 400 k is in a closed system with an initial volume of 0.1 m3. is now compressed in a polytropic process, with exponent of n 1.2, to a temperature of 500 k. calculate: a) the boundary work done during the compression, in kj b) the heat transfer during the compression, in kj

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Apinion having 30 involute teeth of 6,5 module rotates at 220 r/min and transmits 2 kw to a gear wheel having 70 teeth; the addendum on both wheels is 4 of the circular pitch and the angle of obliquity is 200. determine; 3.1 the lengths of the path of approach and the arc of approach 3.2 the normal force between the teeth at an instant when there is only one pair of teeth in contact

Answers: 2

Answer

You know the right answer?

Derive a basic analytical model for the volume build rate of a direct, single-laser SL process in te...

Questions