subject
Engineering, 04.03.2021 03:00 jorge0506

a weight of 20 lb is applied to a cylinder that is full of water. The Piston area is 4.5 inches squared. what is the pressure of the water? round to one "decimal" place.​

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15Β°c, and the outlet water temperature is 50Β°c. the tube wall temperature is 14Β°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 Β°c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
You know the right answer?
a weight of 20 lb is applied to a cylinder that is full of water. The Piston area is 4.5 inches squa...
Questions
question
Physics, 07.10.2019 15:30
question
Mathematics, 07.10.2019 15:30
question
Mathematics, 07.10.2019 15:30
Questions on the website: 13722361