I need help on this question please you guys
...
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Questions
Mathematics, 09.03.2021 09:10
Geography, 09.03.2021 09:10
Physics, 09.03.2021 09:10
Mathematics, 09.03.2021 09:10
History, 09.03.2021 09:10
Social Studies, 09.03.2021 09:10
Mathematics, 09.03.2021 09:10
Chemistry, 09.03.2021 09:10
Chemistry, 09.03.2021 09:10
Mathematics, 09.03.2021 09:10
Biology, 09.03.2021 09:10
Biology, 09.03.2021 09:10
