Engineering, 05.03.2021 06:20 polarbear3787

Styles 6. Match the maintenance requirement to the correct tool in the table below.
There may be more than one correct answer.
Place letter in the column below.
A. Pedestal grinder B
Wipe with a clean cloth and remove dirt and dust
from air vents.
B. Pistol drill
Blades should be replaced when required.
C. Jigsaw
Battery packs should be recharged
D. Portable Sander
Mechanical parts should be lubricated regularly
E. Chainsaw
Dress wheels regularly. Do frequent, light dressings
rather than one heavy dressings.
7. In your words describe the procedure you would follow to correctly position a drill bit when
sharpening it on a bench grinder.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

You know the right answer?

Styles 6. Match the maintenance requirement to the correct tool in the table below.
There may...

Questions