Engineering, 08.03.2021 17:50 emma1581

How do you jump start a car

Answers: 3

Show answers

Answers

Answer from: andrejr0330jr

Jumper cables

Explanation:

Put the ends of a jumper cable on each battery of a car and then turn the engine on and then the turn on the other car and then it should start.

Answer from: krrrr

Take out your jumper cables.

It’s a good idea to buy a set of jumper cables and keep them in the trunk compartment. If you don’t have jumper cables, you have to find a good Samaritan who not only is willing to assist you but who has jumper cables as well.

Place both vehicles in Park or Neutral and shut off the ignition in both cars.

Engage both parking brakes as well.

Attach one of the red clips to the positive terminal of your battery.

It has “POS” or “+” on it, or it’s bigger than the negative terminal.

Attach the other red clip to the positive terminal of the other car.

Attach one of the black clips to the negative terminal on the other battery.

Attach the last black clip to an unpainted metal surface on your car that isn’t near the battery.

Use one of the metal struts that holds the hood open.

To jump start a car, you'll need to make sure you connect the jumper cables in the proper order.

Make sure to connect jumper cables in the proper order.

Start the working vehicle and let the engine run for a few minutes.

Try to start your vehicle.

If it won’t start, make sure that the cables are properly connected and have the good Samaritan run his or her engine for five minutes. Then try to start your car again. If it still won’t start, your battery may be beyond help.

Explanation:

i just want to let you know i think your weird for not just looking it up.

Answer from: Quest

no he didnt use it

explanation:

he said no

Answer from: Quest

the warning light flashes for a second or two when the engine starts. if it stays on, there's must be something wrong with the coolant. you should never dare to continue driving when the light is on. pull over as soon as possible and shut the engine off.

hope this is what you're talking about

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

How do you jump start a car...

Questions