subject
Engineering, 08.03.2021 19:50 genyjoannerubiera

Federal legislation states that "At least 99.9% (3-logs removal and/or inactivation of Giardia lamblia and 99.99% (4-logs) removal and/or inactivation of viruses" is achieved for all surface water treatment. A facility inject chlorine just before the water enter the distribution system. There is no clear well storage and disinfection is done through the distribution system. The first house served by the water treatment facility is located 1 mile from the plant. The pipe of the distribution system is 6 inches in diameter and the maximum flow rate is 2000 gallons per minute. The pH of the water is 7.5, and the temperature is 15 degree C. What will be the total chlorine dose needed to ensure that water reaching the first house has been disinfected to the required level stated above, if the water chlorine demand from organics is 1.5 mg/L, the ammonia content is 1 mg/L NH_3/L.| Tahle 2 C-T Values for of Viruses 4-log 3-log Inactivation InactivationInactivation
Disinfectant 2-log Inactivation 3-log Inactivation 4-log Inactivation
90.0% 99.9% 99.9%
Chlorine 3 4 6
Chloramine 643 1067 1491
Chlorine dioxide 4.2 12.8 25.1
ozone 0.5 0.8 1.0
Giardia inactivation
Log inactivation Ct mg-min/L
0.5 20
1.0 40
1.5 60
2.0 79
2.5 99
3.0 119

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
question
Engineering, 04.07.2019 19:20
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
question
Engineering, 06.07.2019 02:30
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
question
Engineering, 06.07.2019 03:10
List and describe in sequence the operation process steps for boxf machine?
Answers: 1
You know the right answer?
Federal legislation states that "At least 99.9% (3-logs removal and/or inactivation of Giardia lambl...
Questions
question
History, 19.10.2019 18:30
question
Mathematics, 19.10.2019 18:30
question
Mathematics, 19.10.2019 18:30
Questions on the website: 13722360