Engineering, 08.03.2021 20:30 jpwalker9017
Identify the terms used for different types of automation?
Anderson uses stand-alone NC units and flexible manufacturing systems in his factory which engineers refer to as
automation. Linda
uses flow and transfer lines which engineers refer to as
automation.
Answers: 2
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Identify the terms used for different types of automation?
Anderson uses stand-alone NC units and f...
Mathematics, 24.07.2019 14:50
Mathematics, 24.07.2019 14:50
Social Studies, 24.07.2019 14:50
Biology, 24.07.2019 14:50
Biology, 24.07.2019 14:50
Business, 24.07.2019 14:50
Biology, 24.07.2019 14:50
Mathematics, 24.07.2019 14:50