Engineering, 18.03.2021 01:00 Rflaig1129841

If increased productivity in the workplace is an example of the macroeconomic impact of the green economy and increased income from new jobs is an example of its microeconomic impact, then what does this imply about the difference between macroeconomic and microeconomic factors when measuring the green economy’s impact? (Select all that apply.) The green economy’s macroeconomic effects are best seen in broad patterns, and its microeconomic effects in specific events.

The green economy’s macroeconomic effects are best seen from the top down, and its microeconomic effects from the bottom up.

The green economy’s macroeconomic effects are more speculative, and its microeconomic effects are measurable and concrete.

The green economy’s macroeconomic effects are most telling for measuring its true impact, and its microeconomic effects are too short term to be reliable indicators of impact.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acommercial grade cubical freezer, 4 m on a side, has a composite wall consisting of an exterior sheet of 5.0-mm thick plain carbon steel (kst= 60.5 w/m k), an intermediate layer of 100-mm thick polyurethane insulation (kins 0.02 w/m k), and an inner sheet of 5.0- mm thick aluminium alloy (kal polyurethane insulation and both metallic sheets are each characterized by a thermal contact resistance of r 2.5 x 104 m2 k/w. (a) what is the steady-state cooling load that must be maintained by the refrigerator under conditions for which the outer and inner surface temperatures are 25°c and -5°c, respectively? (b) for power saving purpose, which wall material should be increased/reduced in. thickness in order to reduce 50% of the cooling load found in part (a)? redesign the thickness of the proposed material. 177 w/m-k). adhesive interfaces between the q=575.93 w

Answers: 2

Answer

Engineering, 06.07.2019 03:30

State the stress optic law in two dimension and obtain an expression for the same.

Answers: 2

Answer

You know the right answer?

If increased productivity in the workplace is an example of the macroeconomic impact of the green ec...

Questions