subject
Engineering, 19.03.2021 04:50 SM141372

8.9 State whether or not the following statements are true, explaining your reasons: (a) For the same shear angle, there are two rake angles that give the same cutting ratio. (b) For the same depth of cut and rake angle, the type of cutting fluid used has no influence on chip thickness. (c) If the cutting speed, shear angle, and rake angle are known, the chip velocity can be calculated. (d) The chip becomes thinner as the rake angle increases. (e) The function of a chip breaker is to decrease the curvature of the chip.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
question
Engineering, 04.07.2019 19:20
At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2
Answers: 2
You know the right answer?
8.9 State whether or not the following statements are true, explaining your reasons: (a) For the sam...
Questions
question
Physics, 31.08.2019 10:10
question
Social Studies, 31.08.2019 10:10
Questions on the website: 13722359