Engineering, 19.03.2021 16:00 avalianagames
The linear or mean intercept method is one way to estimate the average grain diameter, d. If you have several cross-sections of your sample so you can determine whether the grains are equi-axed (approximately the same length in all directions), rod or columnar shaped, or platy (like a dinner plate), you can increase the accuracy of your estimate by including a shape factor in your calculation.
(i) Use the mean intercept on the schematic microstructure for a hypothetical single phase metal below, to estimate the average grain size. Don't worry about including a shape factor.
Note: Mean intercept length, I = p where L:- measured length of the line(s) on the micrograph, P- number of times the line(s) intersect a grain boundary and M = the magnification of the micrograph; you may need to determine this from the scale bar.
(ii) If you use more than one line and you vary the orientation of your lines will you get a better estimate of the average grain size? Explain your answer in 1-3 bullets.
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
Engineering, 04.07.2019 18:20
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
The linear or mean intercept method is one way to estimate the average grain diameter, d. If you hav...
Biology, 26.11.2019 09:31
Mathematics, 26.11.2019 09:31
Mathematics, 26.11.2019 09:31
Mathematics, 26.11.2019 09:31
Geography, 26.11.2019 09:31
English, 26.11.2019 09:31
Social Studies, 26.11.2019 09:31
Mathematics, 26.11.2019 09:31
Mathematics, 26.11.2019 09:31
Spanish, 26.11.2019 09:31
Biology, 26.11.2019 09:31