Engineering, 19.03.2021 18:20 aniyahrhs1213

You are working as an electrical technician. One day, out in the field, you need an inductor but cannot find one. Looking in your wire supply cabinet, you find a cardboard tube with single-conductor wire wrapped uniformly around it to form a solenoid. You carefully count the turns of wire and find that there are 570 turns. The diameter of the tube is 8.10 cm, and the length of the wire-wrapped portion is 35.0 cm. You pull out your calculator to determine the following. a. the inductance of the coil (in mH)
b. the emf generated in the coil if the current in the wire increases at the rate of 3.00 A/s (Enter the magnitude in mV.)

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

Answer

You know the right answer?

You are working as an electrical technician. One day, out in the field, you need an inductor but can...

Questions