Engineering, 23.03.2021 14:00 tierrag81
E. From the tables of ASME, fillet welding test is required for electrode diameter of 6mm: 1. State all dimensions for fillet weld assembly. 2. Determine the chemical concentration HNO3 required for etching the fillet samples for carbon steel if the acid concentration available in the laboratory is 65%. 3. Determine the requirements for acceptance of macroscopic inspection of fillet welds according to CODE.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
Engineering, 06.07.2019 03:20
Avertical steel rod of length 2.0 m and diameter 25 mm is rigidly fixed at its upper end and has a flange at its lower, free, end. what will be the maximum stress produced in the rod when a load of 20 kn is applied, (a) gradually to the lower end, (b) suddenly to the lower end, (c) by a collar falling from a height of 50 mm on to the flange?
Answers: 3
You know the right answer?
E. From the tables of ASME, fillet welding test is required for electrode diameter of 6mm: 1. State...
Questions
English, 22.09.2019 02:20
Biology, 22.09.2019 02:20
Mathematics, 22.09.2019 02:20
Mathematics, 22.09.2019 02:20
Computers and Technology, 22.09.2019 02:20
Social Studies, 22.09.2019 02:20
English, 22.09.2019 02:20
Biology, 22.09.2019 02:20
History, 22.09.2019 02:20
Social Studies, 22.09.2019 02:20
