Engineering, 25.03.2021 17:10 Otod207
The resistance Ro is adjusted until a maximum power transfer Ro is achieved.
Calculate the value of Ro
2. Calculate the maximum power that can be delivered to Ro.
3. Calculate the short circuit current
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
The resistance Ro is adjusted until a maximum power transfer Ro is achieved.
Calculate the value of...
World Languages, 07.05.2020 11:59
Mathematics, 07.05.2020 11:59
Mathematics, 07.05.2020 11:59
Mathematics, 07.05.2020 11:59
Physics, 07.05.2020 11:59
Biology, 07.05.2020 11:59
Mathematics, 07.05.2020 11:59