1. What's the maximum overall length of the part?
2. What material is used to fabricate the pa...
Engineering, 30.03.2021 16:20 ciel8809
1. What's the maximum overall length of the part?
2. What material is used to fabricate the part
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
You know the right answer?
Questions
Arts, 14.01.2021 18:10
Mathematics, 14.01.2021 18:10
Mathematics, 14.01.2021 18:10
English, 14.01.2021 18:10
Mathematics, 14.01.2021 18:10
Mathematics, 14.01.2021 18:10
Mathematics, 14.01.2021 18:10
Mathematics, 14.01.2021 18:10
