subject
Engineering, 30.03.2021 16:30 bre644

A DNA sequence is a series of components from {A, C, G, T}. Suppose there is one hidden variable S that controls the generation of DNA sequence. S can have 2 possible states: {cg, at}. Both states are equally likely initially. At each time step, the probability of transitioning to the other state is 0.2; otherwise, the state remains the same. In state cg, the probability of observing each of C or G is 0.4, and the probability of observing each of A and T is 0.1. In state at, the probability of observing each of A or T is 0.3, and the probability of observing each of C and G is 0.2. A) Give a precise formulation of this HMM (initial belief, transition and observation probabilities).
B) Recall that an HMM assumes the Markov assumption St L St-k | St-1 for k > 1. Hence we know that S2 L So. Show that this does not imply that S2 is independent of So, i. e., show that S2 is not equal to So. This therefore shows that conditional independence does not imply independence.
Hint: Using the provided model, write out the joint distribution P(So, Si, S2). Then compute the marginal distributions P(So), P(S2), and P(So, S2), and show that these marginal distributions do not satisfy the definition of independence.
C) Suppose we observed the sequence e = TGC ACA. Using the HMM recursive forward filtering equations, compute P(S6|E = e).

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 ยฐf at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
You know the right answer?
A DNA sequence is a series of components from {A, C, G, T}. Suppose there is one hidden variable S t...
Questions
question
Spanish, 03.12.2019 13:31
question
Social Studies, 03.12.2019 13:31
Questions on the website: 13722362