subject
Engineering, 30.03.2021 22:50 myloredo10

A particular unit cell is cubic with ions of type A located at the corners andface centers of the unit cell and ions of type B located at the midpoint ofeach edge of the cube and at the body-centered position. The ions contribute to the unit cell in the usual way (1/8 ion contribution foreach ion at the corners, etc.). A) How many ions of each type are there per unit cell?
B) Describe this structure as a lattice and a basis.
C) What is the coordination number of each ion?
D) What is the name commonly given to this crystal structure?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
A particular unit cell is cubic with ions of type A located at the corners andface centers of the un...
Questions
question
Mathematics, 04.04.2020 05:55
Questions on the website: 13722367