Engineering, 02.04.2021 19:30 acina
Two previously undeformed specimens of the same metal are to be plastically deformed by reducing their cross-sectional areas. One has a circular cross section, and the other is rectangular; during deformation the circular cross section is to remain circular, and the rectangular is to remain as such. Their original and deformed dimensions are as follows:
Circular (Diameter, mm) Rectangular (mm)
Original dimensions 16.4 115x175
Deformed dimensions 10.4 62x200
Required:
Which of these specimens will be the hardest after plastic deformation, and why?
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24ยฐc is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15ยฐc, and the outlet water temperature is 50ยฐc. the tube wall temperature is 14ยฐc higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
You know the right answer?
Two previously undeformed specimens of the same metal are to be plastically deformed by reducing the...
Questions
Physics, 06.04.2020 19:32
Mathematics, 06.04.2020 19:32
Computers and Technology, 06.04.2020 19:32
Mathematics, 06.04.2020 19:32
Mathematics, 06.04.2020 19:32
Mathematics, 06.04.2020 19:32
English, 06.04.2020 19:32
English, 06.04.2020 19:32
