subject
Engineering, 05.04.2021 14:00 trent1002brown

The oblique reservoir manometer shown in the figure consists of a 35 mm diameter vertical reservoir cylinder and a 5 mm diameter tube inclined at an upward angle of 15 °. If the vertical reservoir cylinder is inclined to the atmosphere, the tube opens to the air channel. The manometer is filled with liquid with a specific gravity of 0.785. What will be the pressure in the air duct if the manometer liquid in the inclined tube rises 50 mm upwards?


The oblique reservoir manometer shown in the figure consists of a 35 mm diameter vertical reservoir

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
You know the right answer?
The oblique reservoir manometer shown in the figure consists of a 35 mm diameter vertical reservoir...
Questions
question
Advanced Placement (AP), 16.06.2020 20:57
question
Mathematics, 16.06.2020 20:57
question
Mathematics, 16.06.2020 20:57
question
Mathematics, 16.06.2020 20:57
question
Mathematics, 16.06.2020 20:57
Questions on the website: 13722367