subject
Engineering, 08.04.2021 17:50 dondre54

Consider a parallel plate transmission line that has a width of 3 cm. It is filled with Teflon. Part of the transmission line has a height of 2 mm. The rest of the transmission line has a height of 8 mm. Design a transmission line matching section that will pass 100% of a 200 MHz signal from the narrow height transmission line to the high transmission line. What possible issues arise with your design that are not covered by the transmission line approach

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
You know the right answer?
Consider a parallel plate transmission line that has a width of 3 cm. It is filled with Teflon. Part...
Questions
question
Mathematics, 08.07.2019 05:00
question
Mathematics, 08.07.2019 05:00
Questions on the website: 13722363