Engineering, 09.04.2021 03:20 christopherluckey7

This is a project you can do if you have a bike pump or a syringe (no needle!). When the pump handle is fully-extended, the cylinder of a hand-held bike pump has a volume of 2.0 in3 . If a person holds their thumb over the exit hole (no needles!) and push on the pump handle to compress the air you can increase the pressure in the cylinder. Let us presume that a pressure of 45 lbf/in2 is obtained. Atmospheric pressure is 14.7 psi and the outside temperature is 100 degF. a) Determine the final volume and the final temperature of the gas if the process is done slowly (about 1 hour)
b) Determine the final volume and the final temperature of the gas if the process is done quickly (about 1 second)
c) Be certain to identify and list any assumptions that are needed to answer these questions

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

You know the right answer?

This is a project you can do if you have a bike pump or a syringe (no needle!). When the pump handle...

Questions