Engineering, 12.04.2021 21:40 Jasminanai42
Which option identifies how the machinist will know how large to make the model in the following scenario?
An engineer has just completed his design for a forklift. He hands his designs over to a machinist who will begin working on the model.
A. The engineer used the process of drawing to scale to represent the model.
B. The engineer did not use the process of drawing to scale to represent the model.
C. The engineer included all of the details on one page of the design sketch to avoid confusion.
D. The engineer used several drawings to represent all of the details in the design sketch.
Answers: 3
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:20
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Which option identifies how the machinist will know how large to make the model in the following sce...
Advanced Placement (AP), 02.12.2020 06:40
Chemistry, 02.12.2020 06:40
Mathematics, 02.12.2020 06:40
Mathematics, 02.12.2020 06:40
Arts, 02.12.2020 06:40
Mathematics, 02.12.2020 06:40
Chemistry, 02.12.2020 06:40
Biology, 02.12.2020 06:40
Mathematics, 02.12.2020 06:40
Mathematics, 02.12.2020 06:40
Mathematics, 02.12.2020 06:40
History, 02.12.2020 06:40