Match the following parts of a crane
with the part name by selecting the
corresponding number...
Engineering, 13.04.2021 07:30 alex12354
Match the following parts of a crane
with the part name by selecting the
corresponding number.
Boom head or tip section
Auxiliary or
whip line
Headache bal
or overhaul ball
S.
Deflector (lder) sheaves
2
Main hoist line
1.
3
>
e the
- Main hoist line or falls
2.
Q
Audiary hoist line
5
3.
Boom head tip or
sheaves
nust
4.
Counterweight
Boom pendants (stays)
5.
Load block or main
hook block
Bridie
his
Upperrors or superstructure
refers to the entire crane
structure above the
Swing circle
6.
Live Mast
Boom hoistreering
Boom stops or backstops
7.
Hool, base, but or boom foot section
erect
Lattice boom insert or
sections
Swing circle, ring goar, role path or tumtable
001000
Carrier
Center pin, cater of rotation is of rotation
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
Questions
Computers and Technology, 12.12.2019 20:31
Chemistry, 12.12.2019 20:31
