Engineering, 13.04.2021 20:10 vkyles84

Design a parallel resonant circuit for an AM radio receiver. The inductance can vary to adjust the resonant frequency in order to cover the full AM broadcast band, which is from 530 to 1610 kHz. The circuit bandwidth must be at least 20 kHz in order to reproduce the full station signal, but not too much more than that in order to filter out adjacent stations. The resistor value is 33 kΩ. The inductance varies with a fixed inductor Lfixed in series with a variable inductor that has a range from zero to Lvar in order to cover the broadcast band. Using standard 20% tolerance commercial values, obtain the value of the capacitor and the two inductors. Finally, determine the quality factor range of the circuit from the low end to the high end of the broadcast band. Given: w = 2pif, w0 = 1/sqrt(LC), B = w0/Q, Q = w0RC

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

Answer

You know the right answer?

Design a parallel resonant circuit for an AM radio receiver. The inductance can vary to adjust the r...

Questions