Engineering, 15.04.2021 21:20 Nell3856

PLEASE ANSWER ASAP Select the correct text in the passage.
Below is a manufacturing company's mission statement which sentence in the mission statement goes against Edward Demnings 14 point
program?
Our goal is to improve systems and processes continually and thereby reduce costs. We will provide on-the-job training to all employees to
limpart adequate knowledge. The objective of supervision will be to identify incapable employees that hamper quality and remove them from
the system. Regular meeting between employees and management will ensure employees can express their views and concerns. These
meetings will also enable management to share the vision of the company's growth and transformation with the employees. Our focus
throughout will be on process improvement and quality.

PLEASE ANSWER ASAP

Select the correct text in the passage.
Below is a manufacturing company's mis

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

Arigid tank contains 10 kg of air at 137 kpa (abs) and 21°c. more air is added to the tank until the pressure and temperature rise to 242 kpa (abs) and 32°c, respectively. determine the amount of air added to the tank. [r-0.287 kj/kg k]

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Aheat pump with refrigerant-134a as the working fluid is used to keep a space at 25°c by absorbing heat from geothermal water that enters the evaporator at 500c at a rate of 0.065 kg/s and leaves at 40°c. the refrigerant enters the evaporator at 20°c with a quality of 23 percent and leaves at the inlet pressure as saturated vapor. the refrigerant loses 300 w of heat to the surroundings as it flows through the compressor and the refrigerant leaves the compressor at 1.4 mpa at the same entropy as the inlet. determine: (a) the degrees of subcooling of the refrigerant in the condenser, b)-the mass flow rate of the refrigerant . (c) the heating load and the cop of the pump, and d)-the theoretical minimum power input to the compressor for the same heating load.

Answers: 3

Answer

Engineering, 06.07.2019 04:30

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volume for a gas is much higher than the average volume for a liquid. d)-there is no difference.

Answers: 2

Answer

Engineering, 06.07.2019 05:10

The crank case of an automobile is 80 cm long 30 cm wide and 10 cm deep. find out the rate of heat flow from the crank case to the atmosphere when the automobile is moving at 90 km/hr. assume that the vibration of the engine and the chassis iaduce the transition from laminar to turbulent boundary layer may be considered over the entire surface. also find out the drag force on the total surface of the crank case. take the same average convective heat transfer coefficient and average shear stress for front and rare surfaces as for the bottom rnd sides crank case surface temperature is 75°c and atmospheric air temperature is 5 c

Answers: 2

Answer

You know the right answer?

PLEASE ANSWER ASAP Select the correct text in the passage.
Below is a manufacturing company's...

Questions