Engineering, 20.04.2021 21:00 hayyeet

5. (3 points) We want to support a load of 100 lb at a set distance (15 in.) away from pin and roller supports, which are a set distance (10 in.) apart. We will consider solid, single parts of various shapes. For each shape, determine the types of internal loads (axial, shear, bending, torsion) in each straight portion of each part, but not magnitudes. Then, comment on which shape will likely be most efficient in carrying the load, that is, it will require relatively little material to keep the stress below a maximum value.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:20

The quality is zero at a)-the saturated vapour state b)-the saturated liquid state c)-the saturated liquid-vapour mixture state d)-none of the states in the other answers

Answers: 3

Answer

You know the right answer?

5. (3 points) We want to support a load of 100 lb at a set distance (15 in.) away from pin and rolle...

Questions