Engineering, 27.04.2021 17:50 AutumnJoy12

The gas phase reversible reaction A ↔ B is carried out under high pressure in a packed-bed reactor with pressure drop. The feed consists of both inserts I and Species A with the ratio of inserts to the species A being 2,5 to 1. The molar flow rate of A is 5 mol/min at a temperature of 300K and a concentration of 2,5 mol/dm3. Work this problem in terms of volume Additional information: a/ Adiabatic Operation. Plot X, Xc, T and the rate of disappearance as a function of V up to V=40 dm3. Explain why the curves look the way they do. b/ Vary the ratio of inserts to A (0<ʘt<10) and the entering temperature and describe what you find. c/ Plot the heat that must be removed along the reactor [Q vs V] to maintain isothermal operation

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

You know the right answer?

The gas phase reversible reaction A ↔ B is carried out under high pressure in a packed-bed reactor w...

Questions