Engineering, 28.04.2021 16:30 LarryJoeseph

A. Your femoral mid-shaft cross-section has a periosteal radius of 12 mm and an endosteal radius of 6mm. Assuming it is a perfectly circular hollow cross section, find the cross-sectional area, cross-sectional moment of inertia, and polar moment of inertia. B. Now assume you fracture your femur at the midshaft and the original bone supports zero stress when the femur is loaded in bending. Assume a perfectly circular callus made of woven bone forms on the periosteal surface. If the bending yield stress of the original healthy cortical bone was 180 MPa, and the outer radius of the woven bone callus is 17 mm, what is the bending yield stress of the woven bone if it supports the same bending moment at yield as the original healthy cortical bone

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

You know the right answer?

A. Your femoral mid-shaft cross-section has a periosteal radius of 12 mm and an endosteal radius of...

Questions