Engineering, 29.04.2021 22:50 KaleahV

1. Noise usually caused by the solenoid closing or the pinion gear contacting the flywheel gear. 2. Can operate the lights but may not have enough power to operate the starting motor. 3. Condition where the engine crankshaft does not rotate when the ignition key is turned to the start position. 4. Sound caused by low current flow making the solenoid plunger rapidly kick in and out. 5. Condition that occurs when the engine crankshaft rotates at speeds that are lower than normal. 6. Quickly locates a part with higher-than-normal resistance. 7. Allows the armature to drag or rub on the field pole shoes. 8. Used to check the circuit between the starting motor ground and the negative battery terminal. 9. Distance between pinion and drive end frame with pinion engaged. 10. Used to adjust the space between the pinion gear and the flywheel ring gear.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

You know the right answer?

1. Noise usually caused by the solenoid closing or the pinion gear contacting the flywheel gear. 2....

Questions