Engineering, 03.05.2021 20:30 emo239
This project is a design of secondary treatment units for municipal wastewater treatment for a city. The population of the city is 250,000. Each person generates 300 L wastewater per day that contains 0.085 kg BOD5. The primary settling tank removes 15% of BOD. A conventional suspended activated sludge process is designed to remove the rest up to the discharge standard of 20 mg/L. 1. Characterization of wastewater. From the information about determine the characteristics of the wastewater: a) The daily flowrate b) The BOD5 of the raw wastewater c) The BOD5 after primary settling
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
This project is a design of secondary treatment units for municipal wastewater treatment for a city....
Questions
Physics, 04.08.2020 09:01
Chemistry, 04.08.2020 09:01
English, 04.08.2020 09:01
