Please answer the attached questions.
...
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
Questions
Mathematics, 10.05.2020 08:57
Computers and Technology, 10.05.2020 08:57
Mathematics, 10.05.2020 08:57
Mathematics, 10.05.2020 08:57
Mathematics, 10.05.2020 08:57
Mathematics, 10.05.2020 08:57
Mathematics, 10.05.2020 08:57
Mathematics, 10.05.2020 08:57
English, 10.05.2020 08:57
Mathematics, 10.05.2020 08:57
Social Studies, 10.05.2020 08:57
Medicine, 10.05.2020 08:57
