Engineering, 06.05.2021 16:40 jfghj
You wish to design a cantilever beam with a square cross section and length L that can support an end load of F without yielding. You also wish to minimize the amount the beam deflects under load. Determine the appropriate material performance index to maximize or minimize.
Answers: 3
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
Engineering, 04.07.2019 19:20
Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.
Answers: 3
Engineering, 04.07.2019 19:20
Determine the stoichiometric and actual air-fuel ratios and the mole flue gas composition for combustion with 15% excess air for raw indiana, pennsylvania raw coal.
Answers: 3
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
You wish to design a cantilever beam with a square cross section and length L that can support an en...
Biology, 23.03.2021 01:00
History, 23.03.2021 01:00
Computers and Technology, 23.03.2021 01:00
Arts, 23.03.2021 01:00
Mathematics, 23.03.2021 01:00
Mathematics, 23.03.2021 01:00
Mathematics, 23.03.2021 01:00
Mathematics, 23.03.2021 01:00
Mathematics, 23.03.2021 01:00